From: Green, Simon (Simon.Green@EU.ALTRIA.COM)
Date: Tue May 27 2003 - 12:40:40 EDT
Do you have writesrv running as well?
Simon Green
Altria ITSC Europe s.a.r.l.
AIX-L Archive at http://marc.theaimsgroup.com/?l=aix-l
<http://marc.theaimsgroup.com/?l=aix-l&r=1&w=2> &r=1&w=2
AIX FAQ at http://www.faqs.org/faqs/aix-faq/
<http://www.faqs.org/faqs/aix-faq/>
N.B. Unsolicited email from vendors will not be appreciated.
-----Original Message-----
From: Robert Gullace [mailto:tronix_man@YAHOO.COM]
Sent: 27 May 2003 17:11
To: aix-l@Princeton.EDU
Subject: Qdaemon Problem,
Guys,
I have a question about a box running 4.3.2.0. It involves Qdaemon.
When the system boots qdaemon is started from inittab with the following
line
qdaemon:2:wait:/usr/bin/startsrc -sqdaemon
What my problem is, is that when the process is started, it acts like
it is dead. All print queues go to a dev_wait state. If I do a stopsrc -s
qdaemon -f and kill the process, it dies with no problem. Then I do a
startsrc -s qdaemon and the process is started again. Only this time it
functions with no problems. I have coppid the path from the line in inittab
and run it at teh command line to make sure that all teh pathing was fine.
This is correct it starts up and runs with no prob. If anyone has any ideas
or places that I could go to read up on it or file permissions tha tI should
check, I would greatly appriciate it. If I am correct this problem has been
going on for some time and originated from the system being updated from an
older version of AIX.
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:16:52 EDT