From: Howard Arnold (arnoldh@celerent.com)
Date: Mon May 10 2004 - 13:06:23 EDT
I have a 5.1B cluster which I have just installed Command Scripter 1.0b on
to manage my HSG80. When I issue the command
/usr/opt/CPQcmdscr/bin/cmdscript -f subsysdata it reports that No HS*
controllers are available. A hwmgr -view device -cluster shows the scp0
port. I can also do a /usr/bin/hsxterm5 -b0 -t0 -l0 "show this" and it works
fine.
I have also tried /usr/opt/CPQcmdscr/bin/cmdscript -b 0 -t 0 -l 0 show this
and I get the following:
GetDeviceInfo() failed
Communication failure
I don't have SWCC installed, but the manual implies that it can be used
without an agent.
Output of /usr/bin/hsxterm5 -b0 -t0 -l0 "show this"
Controller: HSG80 ZG10507028 Software V87S-0, Hardware E12
NODE_ID = 5000-1FE1-0010-5B40
ALLOCATION_CLASS = 0
SCSI_VERSION = SCSI-3
Not configured for dual-redundancy
Device Port SCSI address 7
Time: 10-MAY-2004 13:03:05
Command Console LUN is lun 0 (IDENTIFIER = 99)
Host Connection Table is NOT locked
Smart Error Eject Disabled
Host PORT_1:
Reported PORT_ID = 5000-1FE1-0010-5B43
PORT_1_TOPOLOGY = FABRIC (fabric up)
Address = 011000
Host PORT_2:
Reported PORT_ID = 5000-1FE1-0010-5B44
PORT_2_TOPOLOGY = FABRIC (fabric up)
Address = 011100
NOREMOTE_COPY
Cache:
256 megabyte write cache, version 0022
Cache is GOOD
Unflushed data in cache
CACHE_FLUSH_TIMER = DEFAULT (10 seconds)
Mirrored Cache:
Not enabled
Battery: NOUPS MORE THAN 50% CHARGED
Expires: 10-MAY-2006
hsg80t>
Thanks for any help that can be provided.
Howard Arnold
Consultant Engineer
Phone: (603) 685-6060 ext. 206
Email: arnoldh@celerent.com
www.celerent.com
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:58 EDT