From: Andy Malato (andym@oak.njit.edu)
Date: Mon Jul 21 2003 - 15:43:21 EDT
Thanks to all who replied, and gave many good suggestions. I'd like to
thank Shawn Cromer for his suggestion on changing the card's speed
configuration. Changing the card to 10-base half I was able to ping the
outside. I'll have to get in touch with our telecom depart to see if
they can bring that port up to 100-full.
Thanks again for all who contributed.
regards,
---Andy
Shawn's response was as follows:
You can hard set the speed at the PO>>> prompt
PO>>> set ewa0_mode fastfd
The above will set at 100 Full Duplex
fast will be 100 half and twisted will make it 10 half
---Originally Question Below---
> Hi All,
>
> I am running Tru64 UNIX 5.0A and can't seem to get the network card
> working. The card is a DEC TULIP (10/100) Ethernet Interface. I have
> gone through the various network settings over and over and everything
> is configured correctly. I've also tested the network port to make sure
> it wasn't to blame. I also noticed that doing a netstat -r will hang
> for about 5 minutes before returning any values.
>
> /var/adm/messages does show the network interface, so at this point I
> know the card is being detected and I assume at this point it to be
> working.
>
> Does anyone have any suggestions as to what else I can try?
>
>
> Thanks for any suggestions.
>
>
> ---Andy
>
>
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:27 EDT