Summary: login using pre assigned tty device

From: Ashraf Baker (ABaker@DANA.com.jo)
Date: Sun Jun 15 2003 - 06:58:43 EDT

• Next message: Vimal Upreti: "Configuring Network View2.0B on Compaq SAN Appliance"
• Previous message: Andy Malato: "cloning primary system Disk"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear Admins

I'd like to thank "Dr. Thomas P. Blinn"
the soln can be seen in Network administration manul as follows:

1- latcp -A -p630 -HTERMIANLSERVER1 -R PORT_01

 -p for lat device -H then termainal server name " TERMINALSERVER1"
 -R then port no.
to get the above informaition from Termainl server use
local > show server
local > show port 1

2- then the entry to /etc/inittab

lat630:34:respawn:/usr/sbin/getty lat/630 console vt100

3-on termainal server
 local > define port 1 access remote
 local >logout po 1

-----Original Message-----

 Dear admins,
is it allowed to assign specific tty " lat " device to each port of terminal
server, so any one logs in from that port will only his assigned
lat device

thanks vey much

Best regards

• Next message: Vimal Upreti: "Configuring Network View2.0B on Compaq SAN Appliance"
• Previous message: Andy Malato: "cloning primary system Disk"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:23 EDT