From: Boxall Dan (DJBOXALL@qinetiq.com)
Date: Tue Sep 10 2002 - 09:50:23 EDT
> 2100 4/200 Firmware v5.8
> I am trying to load V4.0F onto a box that previously had NT installed on
> it. All drives have been erased, and reconfigured.
> From the >>> I ran arc, and changed the settings to Digital Unix.
> When I boot from CD it seems to come up all right till right at the end
> when it comes up with :
> *** Performing CDROM installation
> Starting Xserver Please wait ...
> 424
> At that point the console blacks out. I can see the arrow or sometimes a
> white box from the mouse , but that is all.
> It is a graphics console, with a SVGA monitor, keyboard and mouse
> connected directly.
> Any advice would be GREATLY appreciated .
>
> Dan Boxall email:djboxall@qinetiq.com
>
After various emails, someone suggested running ECU for Unix.
Following the instructions from ECU menu, went through the various stages
and then exited and saved the configuration. This wrote the necessary
information to NVRAM, and I was then able to carry on as normal with the
installation.
Thanks for all your replies.
Dan
The Information contained in this E-Mail and any subsequent correspondence
is private and is intended solely for the intended recipient(s).
For those other than the recipient any disclosure, copying, distribution,
or any action taken or omitted to be taken in reliance on such information
is prohibited and may be unlawful.
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:48:51 EDT