From: George P. (georgep@nmr.mgh.harvard.edu)
Date: Wed Apr 02 2003 - 11:42:09 EST
Hi all,
I replaced a defective hard drive on an Ultra-10, and booted using a
Solaris 2.7 CD-ROM. I can see the disk ok, and then proceeded with
partitioning (format), and filesystem creation (newfs). I did not run
into any problems.
The issue is that I am unable to complete the Solaris installation on the
new disk. After filling out the network and timezone info, the console
reports that the system identification is complete, but it does not
proceed with installation. If I try to restart the installation, it
reports that the instalation program is already running. I have done this
several times before, and I don't recall running into this. Is there a
way that I can manually force it to proceed after the system
identification is done?
Thank you in advance for your input. Please, let me know if you need me
to provide additional info.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:26:07 EDT