From: George P. (georgep@nmr.mgh.harvard.edu)
Date: Tue Apr 01 2003 - 21:03:33 EST
The resolution settings on my framebuffer were not supported by my PC
monitor. I ended up using m64config to change them.
On a remote terminal (as root), I did the following:
m64config -res 1280x1024x75 try
I would like to thank the following people for their replies:
Ric Anderson <ric@Opus1.COM>
Hichael Morton <mh1272@yahoo.com>
On Tue, 1 Apr 2003, George P. wrote:
> Hi all,
>
> How do I attach a PC monitor to an Ultra-10 running Solaris 2.7? (monitor
> model is 18" NEC/Mitsubishi LCD1850E LCD Flat-Panel Display 1280x1024)
>
> I connected the PC monitor to the SUN PCI card, but the computer doesn't
> "see" it until I physically remove the SUN Creator 3D graphics card. Is
> there a way to be avoid the removal of the SUN graphics card? After
> removing the SUN card, the SUN booting messages appear properly on the PC
> monitor, but right before the system is up, I get the following warning:
>
> Warning: There are no 'nf' devices plumbed and up
> Unable to start NF FDDI SMT/SNM daemon.
> Warning: There are no 'pf' devices plumbed and up
> Unable to start PF FDDI SMT/SNM daemon.
>
> Also, when I try to load openwindows, the screen flickers and at that
> point I just have to kill the process remotely.
>
> Also, how do I attach a PC monitor to an Ultra-5 running Solaris 2.7?
>
> Thank you very much for your input. Please, let me know if you need me to
> provide additional info.
> _______________________________________________
> sunmanagers mailing list
> sunmanagers@sunmanagers.org
> http://www.sunmanagers.org/mailman/listinfo/sunmanagers
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:26:06 EDT