From: B Bong (sunmoon208@yahoo.com)
Date: Wed Nov 13 2002 - 00:59:25 EST
Dear SunManagers,
I have a Netra AC200 machine running Solaris 8 (KJP
108528-16).
I can't bootup Netra T1 AC200 without connect a
terminal console. When Netra AC200 is at OS level and
when I reboot system from remote login, system only
booted up half way. I had waited for more 10 mins but
system did not come up successfully.
After which, I need to use laptop and hyper terminal
for console using serial port. Screen shows that it
stopped at "configuring IPv4 interfaces:"
Then I need to connect the console and it then
successfully bootup. When I disconnect serial cable
from serial port, it can't continue boot until
I need to reconnect cable into serial port again.
>>>
Boot device: disk File and args:
SunOS Release 5.8 Version Generic_108528-16 64-bit
Copyright 1983-2001 Sun Microsystems, Inc. All rights
reserved.
WARNING: invalid vector intr: number 0x7de, pil 0x0
configuring IPv4 interfaces:
<<< hung at this state during booting up
I had already set both the "ttya-ingore-cd=true" and
"ttyb-ingore-cd=true" in my OBP prompt.
I want to know must I connect a serial cable in order
to boot up this Netra AC200 to OS level when I issued
a reboot. If not, what are the things i miss out that
could cause it to stop at that state.
Please enlighten me what could be the possible causes
and how can I narrow down the problem. What parameters
on OBP and LOM should I be checking.
TIA.
Regards,
Bong
U2 on LAUNCH - Exclusive greatest hits videos
http://launch.yahoo.com/u2
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:25:16 EDT