From: Christopher Ferry (chrisf@fortunecity.com)
Date: Tue Sep 24 2002 - 14:07:54 EDT
I have a Sun 4500 6cpu/4gb ram system which seems to have lost its
Drives. The system was running fine about 4 months ago and at some
point it was brought down to cannibalize 2 JNI Gbics. After that the
system sat powered down until 2 weeks ago when I attempted to boot it.
The following is part of the post does anyone have any ideas as to why
the disks are being recognized at boot but not by format?
Also I tried to do a fresh Solaris install and that as well found no
disks. I see the warning about dynamic reconfiguration and the
firmware. Should I just upgrade the firmware and run a boot -r?
Thanks
Chris
0,0> System Board Status
0,0>-----------------------------------------------------------------
0,0> Slot Board Status Board Type Failures
0,0>-----------------------------------------------------------------
0,0> 0 | Normal |+CPU/Memory |
0,0> 1 | Normal |+IO Type 4 |
0,0> 2 | Normal |+CPU/Memory |
0,0> 3 | Normal | Disk Board |
0,0> 4 | Normal |+CPU/Memory |
0,0> 5 | Normal |+IO Type 4 |
0,0> 6 | Not installed | |
0,0> 7 | Not installed | |
0,0> 16 | Normal | Clock Board |
0,0>-----------------------------------------------------------------
0,0>
0,0> CPU Module Status
0,0>-----------------------------------------------------------------
0,0> MID OK Cache Speed Version
0,0>-----------------------------------------------------------------
0,0> 0 | y | 4096 | 336 | 00170011.20000507
0,0> 1 | y | 4096 | 336 | 00170011.20000507
0,0> 4 | y | 4096 | 336 | 00170011.20000507
0,0> 5 | y | 4096 | 336 | 00170011.20000507
0,0> 8 | y | 4096 | 336 | 00170011.20000507
0,0> 9 | y | 4096 | 336 | 00170011.20000507
0,0>-----------------------------------------------------------------
0,0>System Frequency (MHz),fcpu=336, fmod=168, fsys=84, fgen=336
0,0> Populated Memory Bank Status
0,0> bd # Size Address Way Status
0,0> 0 1024 0 4 Normal
0,0> 2 1024 1 4 Normal
0,0> 2 1024 3 4 Normal
0,0> 4 1024 2 4 Normal
0,0>
0,0> Disk Board Status
0,0>-----------------------------------------------------------------
0,0>Slot Sckt0 Sckt1
0,0>-----------------------------------------------------------------
0,0> 3 Disk10 Disk11
0,0>
0,0>
0,0>
POST COMPLETE
0,0>Entering OBP
Switching to high addresses
Setting up TLBs Done
MMU ON
PC = 0000.01ff.f000.1d68
PC = 0000.0000.0000.1dd4
Decompressing in Memory Done
Size = 0000.0000.0006.fe30
ttya initialized
Using POST's System Configuration
Setting up memory
Starting CPU ID 1
Starting CPU ID 4
Starting CPU ID 5
Starting CPU ID 8
Starting CPU ID 9
Clock board TOD does not match TOD on any IO board.
fhc ac simm-status environment sram flashprom SUNW,UltraSPARC-II
SUNW,UltraSPARC-II
fhc ac simm-status environment sram flashprom SUNW,UltraSPARC-II
SUNW,UltraSPARC-II
fhc ac simm-status environment sram flashprom SUNW,UltraSPARC-II
SUNW,UltraSPARC-II
disk-board
Probing UPA Slot at 2,0 sbus fhc ac environment flashprom eeprom
sbus-speed counter-timer
Probing UPA Slot at 3,0 sbus counter-timer
Probing UPA Slot at a,0 sbus fhc ac environment flashprom eeprom
sbus-speed counter-timer
Probing UPA Slot at b,0 sbus counter-timer
Probing /sbus@2,0 at d,0 SUNW,socal sf ssd sf ssd
Probing /sbus@2,0 at 1,0 QLGC,isp sd st
Probing /sbus@2,0 at 2,0 Nothing there
Probing /sbus@3,0 at 3,0 SUNW,hme SUNW,fas sd st
Probing /sbus@3,0 at 0,0 Nothing there
Probing /sbus@a,0 at d,0 SUNW,socal sf ssd sf ssd
Probing /sbus@a,0 at 1,0 Nothing there
Probing /sbus@a,0 at 2,0 Nothing there
Probing /sbus@b,0 at 3,0 SUNW,hme SUNW,fas sd st
Probing /sbus@b,0 at 0,0 Nothing there
screen not found.
Can't open input device.
Keyboard not present. Using ttya for input and output.
Using POST's System Configuration
Setting up memory
Starting CPU ID 1
Starting CPU ID 4
Starting CPU ID 5
Starting CPU ID 8
Starting CPU ID 9
Clock board TOD does not match TOD on any IO board.
fhc ac simm-status environment sram flashprom SUNW,UltraSPARC-II
SUNW,UltraSPARC-II
fhc ac simm-status environment sram flashprom SUNW,UltraSPARC-II
SUNW,UltraSPARC-II
fhc ac simm-status environment sram flashprom SUNW,UltraSPARC-II
SUNW,UltraSPARC-II
disk-board
Probing UPA Slot at 2,0 sbus fhc ac environment flashprom eeprom
sbus-speed counter-timer
Probing UPA Slot at 3,0 sbus counter-timer
Probing UPA Slot at a,0 sbus fhc ac environment flashprom eeprom
sbus-speed counter-timer
Probing UPA Slot at b,0 sbus counter-timer
Probing /sbus@2,0 at d,0 SUNW,socal sf ssd sf ssd
Probing /sbus@2,0 at 1,0 QLGC,isp sd st
Probing /sbus@2,0 at 2,0 Nothing there
Probing /sbus@3,0 at 3,0 SUNW,hme SUNW,fas sd st
Probing /sbus@3,0 at 0,0 Nothing there
Probing /sbus@a,0 at d,0 SUNW,socal sf ssd sf ssd
Probing /sbus@a,0 at 1,0 Nothing there
Probing /sbus@a,0 at 2,0 Nothing there
Probing /sbus@b,0 at 3,0 SUNW,hme SUNW,fas sd st
Probing /sbus@b,0 at 0,0 Nothing there
8-slot Sun Enterprise E4500/E5500, No Keyboard
OpenBoot 3.2.21, 4096 MB memory installed, Serial #10728666.
Ethernet address 8:0:20:a3:b4:da, Host ID: 80a3b4da.
{0} ok boot cdrom -s
Boot device: /sbus@3,0/SUNW,fas@3,8800000/sd@6,0:f File and args: -s
Loading ufs-file-system package 1.4 04 Aug 1995 13:02:54.
FCode UFS Reader 1.11 97/07/10 16:19:15.
Redirected to slice: 1
Loading: /platform/SUNW,Ultra-Enterprise/ufsboot
Loading: /platform/sun4u/ufsboot
SunOS Release 5.8 Version Generic 64-bit
Copyright 1983-2000 Sun Microsystems, Inc. All rights reserved.
WARNING: Firmware does not support Dynamic Reconfiguration
Configuring /dev and /devices
Using RPC Bootparams for network configuration information.
SUNW,hme1 : No response from Ethernet network : Link down -- cable
problem?
Skipping interface hme1
Skipping interface hme0
-
INIT: SINGLE USER MODE
#
#
# format
Searching for disks...done
No disks found!
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:24:58 EDT