From: Paul Hunter (diggerthelab@gmail.com)
Date: Tue Apr 08 2008 - 13:26:00 EDT
I took an image from a V120 and tried to install it on a V210 and get the
following error when booting...
Rebooting with command: boot
Boot device: disk File and args:
sorry, variable 'ecache_scan_rate' is not defined in the 'kernel'
SunOS Release 5.8 Version Generic_117350-46 64-bit
Copyright 1983-2003 Sun Microsystems, Inc. All rights reserved.
WARNING: mc-us3i failed to load
Hardware watchdog enabled
ifconfig: plumb: bge0: Bad file number
moving addresses from failed IPv4 interfaces: bge0 (couldn't move, no
alternative interface).
Hostname: testflar
metainit: testflar: there are no existing databases
The / file system (/dev/rdsk/c1t0d0s0) is being checked.
fsck: could not stat /dev/rdsk/c1t0d0s0: No such file or directory
WARNING - Unable to repair the / filesystem. Run fsck
manually (fsck -F ufs /dev/rdsk/c1t0d0s0). Exit the shell when
done to continue the boot process.
Type control-d to proceed with normal startup,
(or give root password for system maintenance):
single-user privilege assigned to /dev/console.
Entering System Maintenance Mode
This should be possible as they are both sun4u's correct?
Thanks for any tips.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:42:55 EDT