From: Wilkinson, Alex (alex.wilkinson@dsto.defence.gov.au)
Date: Tue May 01 2007 - 04:53:44 EDT
Generally speaking you do have to set up LACP
[http://en.wikipedia.org/wiki/LACP] on the switch ports.
So: 1. Set up LACP on your switch
2. Set up Link Aggregation via dladm(1m) on Solaris.
See the following discussion:
[http://www.opensolaris.org/jive/thread.jspa?threadID=20152]
Thanks to:
Darren Dunham
Johan Hartzenbe
Original Question:
0n Tue, Apr 24, 2007 at 01:08:32PM +0800, Wilkinson, Alex wrote:
>Hi all,
>
>I have link aggregation set up on a T2000 via 4 e1000g(7D) ports.
>
> key: 1 (0x0001) policy: L4 address: 0:14:4f:2:7f:38 (auto)
> device address speed duplex link state
> e1000g0 0:14:4f:2:7f:38 1000 Mbps full up attached
> e1000g1 0:14:4f:2:7f:39 1000 Mbps full up attached
> e1000g2 0:14:4f:2:7f:3a 1000 Mbps full up attached
> e1000g3 0:14:4f:2:7f:3b 1000 Mbps full up attached
>
>Question:
>
>Do I need to turn on EtherChannel (LACP or PAgP) on my Cisco switch also ?
>Or will just having nick aggregation set up via dladm(1m) on Solaris be enough ?
>
> -aW
-aW
IMPORTANT: This email remains the property of the Australian Defence Organisation and is subject to the jurisdiction of section 70 of the CRIMES ACT 1914. If you have received this email in error, you are requested to contact the sender and delete the email.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:41:55 EDT