From: Engle, Victor (Victor.Engle@csd.disa.mil)
Date: Thu Apr 06 2006 - 14:10:47 EDT
Hello List,
I have a Sun 1280 with a Sun Branded Qlogic dual port card. I have both
ports connected to different SAN fabrics and have storage from a Hitachi
9585 presented to both paths.
I have enabled mpxio globally in scsi_vhci.conf and added the following
to support the 9585
device-type-scsi-options-list="HITACHI DF600F";
This is what scsi inquire from format returns
format> inq
Vendor: HITACHI
Product: DF600F
Revision: 0000
format>
I rebooted but when I check format I do not have vhci devices...
21. c3t50060E8000C42350d20 <HITACHI-DF600F-0000 cyl 14579 alt 2 hd
50 sec 768>
/ssm@0,0/pci@18,700000/SUNW,qlc@1/fp@0,0/ssd@w50060e8000c42350,14
/ssm@0,0/pci@18,700000/SUNW,qlc@1/fp@0,0/ssd@w5006016830600d12,0
24. c4t50060E8000C42355d1 <HITACHI-DF600F-0000 cyl 14579 alt 2 hd
50 sec 768>
/ssm@0,0/pci@18,700000/SUNW,qlc@1,1/fp@0,0/ssd@w50060e8000c42355,1
Yet, luxadm recognizes that the devices have multiple paths.
luxadm display /dev/rdsk/c4t50060E8000C42355d20s2
DEVICE PROPERTIES for disk: /dev/rdsk/c4t50060E8000C42355d20s2
Vendor: HITACHI
Product ID: DF600F
Revision: 0000
Serial Num: D60H1B2507D2
Unformatted capacity: 273410.000 MBytes
Read Cache: Enabled
Minimum prefetch: 0x0
Maximum prefetch: 0x0
Device Type: Disk device
Path(s):
/dev/rdsk/c4t50060E8000C42355d20s2
/devices/ssm@0,0/pci@18,700000/SUNW,qlc@1,1/fp@0,0/ssd@w50060e8000c42355
,14:c,raw
LUN path port WWN: 50060e8000c42355
Host controller port WWN: 210100e08b375f62
Path status: O.K.
/dev/rdsk/c3t50060E8000C42350d20s2
/devices/ssm@0,0/pci@18,700000/SUNW,qlc@1/fp@0,0/ssd@w50060e8000c42350,1
4:c,raw
LUN path port WWN: 50060e8000c42350
Host controller port WWN: 210000e08b175f62
Path status: O.K.
Any ideas about what is wrong?
Thanks,
Vic Engle
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:39:32 EDT