From: Thavasimuthu, Arunkumar (Arunkumar.T@ap.sony.com)
Date: Thu Jun 27 2002 - 23:40:35 EDT
Hi all,
I have a Storagetek Tape Libraray L180 with IBM Ultrium LTO tape drives
which are connected through a Fibre Channel bridges and a switch to Sun Fire
v880R server on Qlogic QLA2200 adapter. There are 4 tape drives in the
library
I have two problems:
1). I am able to see only one drive out of 4 drives, when issue the command
at boot prom
OK probe-scsi-all
or
OK select <Qlogic adapter>
OK show-children
But when I use the Qlogic Utility after boot the server, I could see all the
four drives and the www numbers for the corresponding drives
2). After I issued boot -rv I was unable to configure the st driver for the
one drive which has been detected. i.e no entries in /dev/rmt for the drive.
Do I need to add any entries in st.conf for the IBM ultrium LTO tape drives
If anybody encountered this kind of peoblems please share with me.
Thanks & Regards
Arun
-------------------------------------------------------------------
This email is confidential and intended only for the use of the individual
or entity named above and may contain information that is privileged. If you
are not the intended recipient, you are notified that any dissemination,
distribution or copying of this email is strictly prohibited. If you have
received this email in error, please notify us immediately by return email
or telephone and destroy the original message. Thank you. - This mail is
sent via Sony Asia Pacific Mail Gateway.
-------------------------------------------------------------------
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:24:31 EDT