VxVM failure at boot

From: Dragos Stoichitescu (Dragos.Stoichitescu@connex.ro)
Date: Fri Jan 07 2005 - 09:20:14 EST

• Next message: Rob Wichterman: "Can't run any commands"
• Previous message: simonb: "E280R build from ufsrestore"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi,

I have a sunfire 280R with Solaris 8 and VxVM 3.5 (modinfo showed VxVM
3.5s); the boot disks are mirrored; all filesystems are ufs
I applied the latest patches for VxVM and vxfs (that's all that I have
installed) and rebooted; after reboot it hangs when doing " VxVM
starting in boot mode..." and then it does nothing else.
I also tried boot -s but I got the same result ....

(I know I could try to boot from cdrom , disable VxVM & unencapsulate
boot disk - manually - and boot ... but then what ?? I just remove the
pathes applied ??)

Any ideas where to start looking to diagnose this error ??

regards

Dragos
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers

• Next message: Rob Wichterman: "Can't run any commands"
• Previous message: simonb: "E280R build from ufsrestore"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:29:57 EDT