From: Geon Reuben (geomonap@rediffmail.com)
Date: Wed Jan 05 2005 - 14:39:39 EST
Hi guys, I am connecting to a 280R from my laptop via serial. After I cold
boot the system, I see the outpu and the ok prompt, however I don't see any
output when I type. Below is the message I see after I cold boot:
----------------------------------------
~
screen not found.
keyboard not
found.
Keyboard not present. Using ttya for input and output.
Sun Fire 280R
(2 X UltraSPARC-III+) , No Keyboard
Copyright 1998-2003 Sun Microsystems, Inc.
All rights reserved.
OpenBoot 4.10.11, 1024 MB memory installed, Serial
#51905316.
Ethernet address 0:3:ba:18:3:24, Host ID: 83180324.
Boot device:
/pci@8,600000/SUNW,qlc@4/fp@0,0/disk@w21000004cf9f33e1,0:a File and args:
Boot load failed.
The file just loaded does not appear to be executable.
{0}
ok
-----------------------------------------
The baud rate set is 9600, data
bits is 8, parity is none, stop bits is 1. Any ideas on what I need to do to
see ouput when I type ?
I don't have any graphics card on the svr and so
serial connection. This is a virgin system and hence am not sure how else to
connect to it. Resolvig this issue very critical so that I can proceed forward
and load the OS on the server. Your ideas would be appreciated.
Regards,
GR
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:29:57 EDT