From: Patrick.McDermott@bedbath.com
Date: Tue Aug 31 2004 - 09:50:30 EDT
Hey everyone,
I have just set up a Sun Fire V210 server. I want to make sure that the
interface is getting set to 100 full duplex. However, this interface does
not seem to accept the link_mode option to the ndd command:
# ndd -get /dev/bge0 link_speed
100
# ndd -get /dev/bge0 link_status
1
# ndd -get /dev/bge0 link_mode
operation failed: Invalid argument
# ndd -get /dev/bge link_mode
operation failed: Invalid argument
Does anybody know how I can check the duplex setting on this interface?
According to the boot messages, it's coming up as half duplex, but I'd like
to know how to confirm this. Thanks,
PJ
------------------------------------------------------
CONFIDENTIALITY NOTICE: This e-mail, and any attachments thereto, is
intended only for use by the addressee(s) named herein and may contain
confidential information. If you are not the intended recipient of this
e-mail, you are hereby notified that any dissemination, distribution or
copying of this e-mail, and any attachments thereto, is strictly
prohibited. If you have received this e-mail in error, please permanently
delete the original and any copy of any e-mail and any printout thereof.
Thank you for your compliance.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:29:22 EDT