From: Erwin Broschinski (broschi@id.ethz.ch)
Date: Wed Mar 17 2004 - 04:19:28 EST
Hi
I have a Storedege 3310 attached to a V120 running 5.8 Generic_108528-29
I want to have just one LUN to this one host.
The top left and top right SCSI connectors on the rear of the 3310 are
connected, the V120 is attached to the top middle connector like this:
_______________
& to V120
___________&___________
| & |
[.....] [.....] [.....]
[.....] [.....] [.....]
Using the serial interface menu on the 3310 I have created one logical drive
with RAID5, one spare disk, giving a total of 1.3TB.
I can see this in 'sccli' with 'show configuration' (on the V120):
LD LD-ID Size Assigned Type Disks Spare Failed Status
-------------------------------------------------------------------------
ld0 2AA4D344 1.33TB Primary RAID5 11 1 0 Good
* logical-volumes
LV LV-ID Size Assigned LDs
-----------------------------------------
lv0 792EF2DE 1.33TB Primary 1 ld0
* partitions
LD/LV ID-Partition Size
-------------------------------
ld0-00 2AA4D344-00 1.33TB
lv0-00 792EF2DE-00 1.33TB
Problem: I can see the 3310 with probe-scsi-all, but it does not show in
======= 'format' after a reconfigure boot :^((
The logical volume has been created in a second step, it did not make any
difference.
I have also connected the SCSI host cable to the lower left connector. No
difference after a reconfigure boot.
There is a SUN Doc ID 70146, giving a similar problem for a Dual Ultra3 SCSI
Adapter which I am not using.
(Also: the 'ssconsole' program which can be used for configuration comes up
with 2 almost empty windows that just stay like this ??)
Any help is very much appreciated.
Thanx in advance
Erwin
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:28:17 EDT