From: M.Russell@iaea.org
Date: Fri Sep 12 2003 - 08:39:12 EDT
I recently became responsible for a SunBlade 100 server running with Solaris
8. I need to perform a system backup to tape before installing additional
software which must be installed within the next couple of weeks. I have
available an old SUN tape unit, Model 411, Service Number X844A-NC, and 160M
8mm tapes. I have ordered a cable to connect the 50 pin connector in the
old tape drive to the narrow 68 pin connector in the SCSI card. I would
greatly appreciate advice as to:
1. the steps required to connect this old tape drive to the new SunBlade
100, and
2. if I need to download and install a special device driver from somewhere
so that this tape unit will be recognized, where can I find it?
Many thanks in advance.
Marian Russell
Vienna, Austria
This email message is intended only for the use of the named recipient.
Information contained in this email message and its attachments may be
privileged, confidential and protected from disclosure. If you are not the
intended recipient, please do not read, copy, use or disclose this
communication to others. Also please notify the sender by replying to this
message and then delete it from your system.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:27:06 EDT