[HPADM] Configuration setting for HP-PB 100 BASE TX card

From: Julian Rogan (Julian.Rogan@Unilever.com)
Date: Wed Feb 05 2003 - 08:51:19 EST

Next message: Ruth Hutchings: "[HPADM] Ignite 3.7 install A/B version issues"
Previous message: AVGOUSTAKIS,DIMITRI (HP-Belgium,ex1): "[HPADM] security question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi,
I have a HP-PB 100 BASE TX card (btlan1) card on a K360 running 10.20. It
is currently set to 10 MBt Half Duplex. I believe this can be set to 100
Mbt Full Duplex. I modified the file /etc/rc.config.d/hpbasetconf to
have the value "HP_BASET_DUPLEX[0]=FD". I was given this value by HP
support. However on reboot this failed with the message "ERROR: Invalid
duplex value [FD] for lan3 interface".
Is this saying that the value "FD" is invalid. If so does anyone know the
correct value to be used here?
Or is it saying that this card cannot be set to 100 Mbt full duplex?

regards,

Julian

--
             ---> Please post QUESTIONS and SUMMARIES only!! <---
        To subscribe/unsubscribe to this list, contact majordomo@dutchworks.nl
       Name: hpux-admin@dutchworks.nl     Owner: owner-hpux-admin@dutchworks.nl
 
 Archives:  ftp.dutchworks.nl:/pub/digests/hpux-admin       (FTP, browse only)
            http://www.dutchworks.nl/htbin/hpsysadmin   (Web, browse & search)

Next message: Ruth Hutchings: "[HPADM] Ignite 3.7 install A/B version issues"
Previous message: AVGOUSTAKIS,DIMITRI (HP-Belgium,ex1): "[HPADM] security question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 11:02:25 EDT