From: JOSEPH KREMBLAS (jkremblas@REDHEARTGIFTS.COM)
Date: Wed Jan 21 2004 - 11:12:46 EST
This is a block size problem. I've seen this guy way too many times. Check
your adapter settings. Change block size to 0 if needed and retry.
-----Original Message-----
From: IBM AIX Discussion List [mailto:aix-l@Princeton.EDU] On Behalf Of
fmu@OERAG.DE
Sent: Wednesday, January 21, 2004 7:30 AM
To: aix-l@Princeton.EDU
Subject: problem with tctl-command after AIX migration to 5.1
Hi *,
I migrate one from our MCA wide nodes from AIX 4.3.3 to AIX 5.1. On this
node hangs over S/370 Channel Adapter two 3490E tape drives.
Now I check the tctl-command. Always runs fine, but not the rewind-, the
offline- and the rewoffl - subcommand. Read-, write-, status- and the rest
is o.k.
I get the following info, when I start tctl -f/dev/rmt0 rewind:
"/dev/rmt0 rewind 1 failed: A system call received a parameter that is not
valid"
The same result with mt - commands.
With tapeutil I can rewind and checkout the tape.
Any infos??? What can I do? Any additional commands which can I test?
Frank Mueller
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:17:31 EDT