p650 LPAR- rmdev active scsi adapter?

From: Clifton, Pablo (Pablo.Clifton@BCBSFL.COM)
Date: Fri Aug 08 2003 - 18:02:42 EDT

Hi-

Does anyone know how to clean up these SCSI adapter logical names below on a p650 LPAR:

SCSI ADAPTERS:
        root@host:/:>lsdev -Cc adapter | grep scsi

        scsi2 Available 14-08 Wide/Ultra-3 SCSI I/O Controller [[ ACTIVE ]]
        scsi0 Available 14-09 Wide/Ultra-3 SCSI I/O Controller

SCSI DISKS:
        root@host:/:>lsdev -Cs scsi

        hdisk0 Available 14-08-00-10,0 16 Bit LVD SCSI Disk Drive
        hdisk1 Available 14-08-00-11,0 16 Bit LVD SCSI Disk Drive
        ses2 Available 14-08-00-15,0 SCSI Enclosure Services Device

scsi2 should be scsi0 (14-08)
and scsi0 should be scsi1 (14-09)

I tried to boot into maintenance mode from a NIM server and run "rmdev -dl scsi2" but I get a
" Method error (/usr/lib/methods/ucfgncr_scsi)".

thanks,
-pablo 

---
Pablo Clifton
UNIX Administration
Blue Cross Blue Shield of Florida, Inc., and its subsidiary and affiliate companies are not responsible for errors or omissions in this e-mail message. Any personal comments made in this e-mail do not reflect the views of Blue Cross Blue Shield of Florida, Inc.  The information contained in this document may be confidential and intended solely for the use of the individual or entity to whom it is addressed.  This document may contain material that is privileged or protected from disclosure under applicable law.  If you are not the intended recipient or the individual responsible for delivering to the intended recipient, please (1) be advised that any use, dissemination, forwarding, or copying of this document IS STRICTLY PROHIBITED; and (2) notify sender immediately by telephone and destroy the document. THANK YOU.

This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:17:07 EDT