From: Ferenc Gyurcsan (fgyurcsa@AVAILANT.COM)
Date: Fri Aug 08 2003 - 09:12:30 EDT
You _could_ just start HACMP on both nodes, and if there is really no
connection, you will see that the rs232 network never comes up. But if the
stty test fails, it is very likely that HACMP will say the same. Note that
on some nodes (especially the newer ones), some of the ttys are not
supported with HACMP (tty0 is one of them). This is because of the service
processor, and you could get in real trouble if you were to use it. This is
documented somewhere, with exact model numbers and ttys.
--Ferenc
-----Original Message-----
From: Shekhar Dhotre [mailto:Shekhar.Dhotre@LENDLEASEREI.COM]
Sent: 07 August 2003 21:05
To: aix-l@Princeton.EDU
Subject: Re: HACMP question
Sbodily/Green ,
Thanks for Support Matrix ...
I am testing tty connection for HACMP configuration but its not responding
to stty < /dev/tty0 command . Is there any other way to test ttty connection
between two nodes .
<SNIP>
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:17:07 EDT