From: Green, Simon (SGreen@KRAFTEUROPE.COM)
Date: Mon Dec 09 2002 - 10:59:10 EST
I don't know much about LPAR yet, (got a course next week), so forgive me if
I'm being stupid...
For a very crude answer, you could always physically move the tape drive.
Or even buy an extra one, if it's something basic like a DLT drive. You
might look into hiring one for a short time. (I assume the problem is not
the tape drive as such; rather the adapter card it's connected to.)
You could set up NIM. Of course, that's quite a bit of trouble so if you're
planning to do the SP Attach soon it might not be worth it.
There have been some posts about building mksysb images on remote tape
drives and/or from a mksysb to disk. You could do something like that,
accepting that you may have to do some messing around when you come to
restore if the tape drive is in the wrong LPAR. You may need to invest a
little time in searching the archives.
Simon Green
Philip Morris ITSC Europe
AIX-L Archive at http://marc.theaimsgroup.com/?l=aix-l&r=1&w=2
AIX FAQ at http://www.faqs.org/faqs/aix-faq/
N.B. Unsolicited email from vendors will seldom be appreciated.
> -----Original Message-----
> From: Bill Verzal [mailto:Bill_Verzal@BCBSIL.COM]
> Sent: 09 December 2002 15:29
> To: aix-l@Princeton.EDU
> Subject: Re: LPAR thoughts
>
>
> Well, moving around a tape drive. To move around a tape
> drive in AIX 5.1
> requires an LPAR reboot. Under 5.2 it does not.
> Unfortunately, our APP
> (Siebel) is not yet certified for 5.2. We are planning to
> SP-attach the
> LPAR's, which makes the mksysb issue go away, however, until
> then we need
> to come up with a solution.
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:16:24 EDT