From: pSeries AIX Geek (aixgeek@YAHOO.COM)
Date: Thu Nov 07 2002 - 15:04:19 EST
Have a Brocade switch (Silkworm 12000). Attaching an
S80 that has three fiber cards (6228s).
When I go into the WWN Zoning menus on the switch (to
start creating an alias), only the WWN for fcs0
appears automatically. I'm kind of used to just
plugging in the switches and at least seeing that the
WWN has been recognized on the switch (then I can set
up my aliases, zones, etc.).
Any reason why the other two won't show up? My gut
reaction is that this a cable problem. But, we're
getting all the lights lit on both ends, as I would
expect.
Again, this is just at the switch level -- AIX seems
to be OK (no error report entries, all the 2105 device
drivers are installed for the eventual Shark
attachment, etc.).
I apologize for the probably off-topicness, but does
anyone have any ideas or can confirm my suspicion that
this is really just a cable problem.
[The machine and switch are 1500 miles away.]
-pAG
__________________________________________________
Do you Yahoo!?
U2 on LAUNCH - Exclusive greatest hits videos
http://launch.yahoo.com/u2
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:16:19 EDT