From: cuihh cuihh (cuihh6@HOTMAIL.COM)
Date: Fri Apr 09 2004 - 09:05:38 EDT
Why the raid10 ssa array not switch to offline state ?
I have established a raid10 ssa array on 7133-D40("pdisk0,pdisk1,pdisk2" as
the primary disks and "pdisk3 pdisk4 pdisk5" as the secondary disks and the
"Split Array Resolution" was set to Primary)
>From "Advanced SerialRAID Adapters user's guide and maintanence
information" Page 37, One of the case that would lead the raid10 array to
offline state is listed :
All these three conditions exist:
– In the secondary half of the array, the member disk drive that contains
the
configuration sector is present.
– In the primary half of the array, no members that hold configuration
sectors are
present.
– The Split Array Resolution flag is not set.
So i try to make my raid10 array into offline state:
I unplug the pdisk0 pdisk1 pdisk2 which were the primary disks of the
raid10 array from the 7133-D40 and found that the
raid10 array became exposed state . 10 minutes later , the array was not in
offline state but still in exposed state
Why ?
What on earth should i do in order to make the raid10 array into offline
state ?
_________________________________________________________________
享用世界上最大的电子邮件系统— MSN Hotmail。 http://www.hotmail.com
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 22:17:49 EDT