shutdown due to overtemp

From: Stephen Everse (sje@sbb.uvm.edu)
Date: Tue Jan 08 2008 - 20:58:49 EST

• Next message: Franz Fischer: "scroll wheel support in Tru64 5.1B-3"
• Previous message: Halte, James : "ES40 user auth. messages not going to syslog"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi--

This afternoon I had one of my ES40s shutdown with an
overtemp error. If I enter RMC I see that Zone0 is
49C whereas all my other zones are measuring 28C-- I
also noticed the system is giving a 12V bulk warning
on boot. From what I have read Zone0 is a sensor located
near PCI slots 1-3 and Zone1 is slots 7-10 and Zone2 4-6.
Could the sensor just be bad or dirty? Do I need to replace
the backplane? Where is the sensor so I could try cleaning
it?

My reading also indicates that if RMC env command reports
all is well powerwise-- and the SRM show power command
says things are ok that I need to replace my system board.
Has that been others experiences also?

Thanks for your insights!

Stephen

• Next message: Franz Fischer: "scroll wheel support in Tru64 5.1B-3"
• Previous message: Halte, James : "ES40 user auth. messages not going to syslog"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:50:36 EDT