From: Greg Rudd (G.Rudd@isu.usyd.edu.au)
Date: Mon Oct 30 2006 - 02:52:53 EST
Hi all
I dont know if i have a problem with my trucluster config but after I
reboot the cluster after running the clu_create_cluster command to
create a single node cluster, it is claiming that the cluster alias ip
address in use by the hardware address which is used by the public node
ip address
Oct 30 11:27:07 romeo vmunix: arp: local IP address 172.17.13.194 in use
by hardware address 00-17-A4-3D-DF-E2
Is this caused by gated not runnig? Eventhough the clu_create_cluster
said it was going to configure it for the interconnect which is using
1gb (nr0) eithernet.
bash-3.00# ifconfig -a |more
bcm0: flags=c63<UP,BROADCAST,NOTRAILERS,RUNNING,MULTICAST,SIMPLEX>
inet 172.17.13.192 netmask ffffff00 broadcast 172.17.13.255 ipmtu
1500
bcm1:
flags=5000c63<UP,BROADCAST,NOTRAILERS,RUNNING,MULTICAST,SIMPLEX,CLUIF,RESE
RVED>
NetRAIN Virtual Interface: nr0
NetRAIN Attached Interfaces: ( bcm1 ) Active Interface: ( bcm1 )
ics0: flags=1100063<UP,BROADCAST,NOTRAILERS,RUNNING,NOCHECKSUM,CLUIF>
inet 10.0.0.1 netmask ffffff00 broadcast 10.0.0.255 ipmtu 7000
lo0: flags=100c89<UP,LOOPBACK,NOARP,MULTICAST,SIMPLEX,NOCHECKSUM>
inet 127.0.0.1 netmask ff000000 ipmtu 4096
nr0:
flags=1000c63<UP,BROADCAST,NOTRAILERS,RUNNING,MULTICAST,SIMPLEX,CLUIF>
NetRAIN Attached Interfaces: ( bcm1 ) Active Interface: ( bcm1 )
inet 10.1.0.1 netmask ffffff00 broadcast 10.1.0.255 ipmtu 1500
sl0: flags=10<POINTOPOINT>
tun0: flags=80<NOARP>
tun1: flags=80<NOARP>
So is this message just an informational, or have I not done something
here that I should have. As the manuals don't point to doing anything
more than defining the main cluster using clu_create.
OS: Tru64 5.1B with NHD7 with the included tru cluster patches.
Thanks in advance
-greg
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:50:32 EDT