From: Andy Kannberg (a.kannberg@wanadoo.nl)
Date: Fri Apr 14 2006 - 07:17:58 EDT
Hi,
A while ago, I asked how I could figure out the relation between the output of disks on the storagecontroller and at OS level.
I said that the controller was a HSG80 but actually, it is a HSZ80. But, nevertheless I tried to set the IDENTIFIER parameter as told by
David J. DeWolfe, Andrew Raine and Hans Verhoef advised me. But the HSZ80 doesn't have a parameter called IDENTIFIER.
Here's a little of the output :
UPPER HSZ80>set D604 IDENTIFIER = 604
^
Command syntax error at or near here
UPPER HSZ80>set D604 IDENTU
^
Command syntax error at or near here
UPPER HSZ80>set D604 ?
Your options are:
ENABLE_ACCESS_PATH = [get help at a lower level]
DISABLE_ACCESS_PATH = [get help at a lower level]
MAXIMUM_CACHED_TRANSFER_SIZE = (decimal value)
READ_CACHE
NOREAD_CACHE
READAHEAD_CACHE
NOREADAHEAD_CACHE
RUN
NORUN
WRITEBACK_CACHE
NOWRITEBACK_CACHE
WRITE_PROTECT
NOWRITE_PROTECT
UPPER HSZ80>
As you can see, I can't set anything like IDENTIFIER.
Does anybody know how this works on a HSZ80 ?
best regards,
Andy Kannberg
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:50:29 EDT