From: rob.leadbeater@lynx.co.uk
Date: Wed May 05 2004 - 13:03:55 EDT
Hi managers,
I've got a two node ES47 5.1B cluster, using dual memory channel cards
and hubs as the cluster interconnect.
Whilst checking my firewall logs I noticed some NTP traffic going over
the ethernet that should be going over the cluster interconnect.
Digging a bit further showed that on one node, ics0 hasn't got an IP
address for some reason.
Node 1 shows the following with an ifconfig -a:
ics0: flags=1100063<UP,BROADCAST,NOTRAILERS,RUNNING,NOCHECKSUM,CLUIF>
inet 192.168.0.3 netmask ffffff00 broadcast 192.168.0.255 ipmtu 7000
Node 2 shows just this:
ics0: flags=1100022<BROADCAST,NOTRAILERS,NOCHECKSUM,CLUIF>
Running clu_check_config shows that I can't see node2-ics0
node1 # clu_check_config
Starting Cluster Configuration Check...
node2-ics0: Connection timed out
node2-ics0: Connection timed out
node2 # clu_check_config
Starting Cluster Configuration Check...
node1-ics0: Connection timed out
node2-ics0: Connection timed out
node1-ics0: Connection timed out
node2-ics0: Connection timed out
How do I go about configuring the correct IP address on the cluster
interconnect of node2 ?
Regards,
Rob Leadbeater
This message is intended only for the use of the person(s) ("The intended
Recipient(s)") to whom it is addressed. It may contain information which
is privileged and confidential within the meaning of applicable law. If
you are not the intended recipient, please contact the sender as soon as
possible. The views expressed in this communication are not necessarily
those held by LYNX Express Limited.
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:58 EDT