From: Urey, Dawn (UreyD@pginw.com)
Date: Thu Feb 19 2004 - 10:39:37 EST
Thanks for all of the responses.
The general consensus is, "if it's not broken, don't fix it".
Apparently, when the cluster is established, it assigns NETDEV_0="tu0".
When you run clu_add_member, it sets NETDEV_0="ics0".
Thanks to Dr. Blinn for this answer:
If I were changing it, I'd list the physical hardware interface (in this
case, "tu0" on both systems) first, not the logical name used by TruCluster
(the "ics0" on both systems). But I checked my V5.1B cluster, and it's the
same way, the node that was installed first has NETDEV_0="tu0" and the node
that was added with clu_add_member has NETDEV_1="tu0" (and reflexively for
the "ics0"), and it works just fine.
So my advice is, it isn't broken, don't try to fix it.
-----Original Message-----
From: Urey, Dawn
Sent: Thursday, February 19, 2004 10:12 AM
To: 'Tru64 Managers'
Subject: rc.config
All:
I have 2 separate Truclusters. Both are running 5.1A patchkit 5. On one of
the clusters, the rc.config lists
NETDEV_0="isc0'"
NETDEV_1="tu0"
On the other cluster, rc.config lists
NETDEV_0="tu0"
NETDEV_1="ics0"
Does the way the network devices are defined cause any performance issues?
Should ics0 be NETDEV_0?
Thanks,
Dawn
Dawn Urey
PGI
Systems and Site Support Manager
(919)874-9512
------------ PGI Internet E-mail Confidentiality ------------ Please note:
This message may contain information which is privileged and confidential.
If you are not the intended recipient, you are hereby notified that any
dissemination, distribution or copying of this communication is strictly
prohibited. If you believe you have received this message in error, please
forward to Postmaster@pginw.com.
------------ Confidencialidad de Correo Electronico de PGI ------------
Nota: Este mensaje puede contener informacion privilegiada y confidencial.
Si usted no es el destinatario, esta notificado que cualquier diseminacion,
distribucion o copia de esta comunicacion esta estrictamente prohibida. Si
usted cree que ha recibido este mensaje por error, por favor reenvielo a
Postmaster@pginw.com. (Informacion intencionalmente sin acentos)
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:51 EDT