From: Jess Balint (dollzerr@iwaynet.net)
Date: Mon Aug 11 2003 - 21:14:20 EDT
Hi all, I am running Tru64 5.0. I am getting the following message
multiple times upon boot:
Aug 11 20:20:10 empire vmunix: Active CCB at time of error
Aug 11 20:20:10 empire vmunix: cam_logger: SCSI event packet
Aug 11 20:20:10 empire vmunix: cam_logger: bus 3 target 3 lun 0
Aug 11 20:20:10 empire vmunix: isp_process_response_queue
Aug 11 20:20:10 empire vmunix: No autosense after C C: 1700 81
I can't read any tapes either. I inserted the cleaning tape, but it
popped right back up. Writing tapes seems to work OK. This drive is a
Sony SDT-7000 DDS-2.
Is my tape drive going old and bad, or is there a hardware/software
issue?
I have included hwmgr attributes at bottom if that is any indication.
Thanks.
Jess
47:
path_port_id_3 = 3
path_target_id_3 = 3
path_lun_id_3 = 0
path_dev_i/o_cnt_3 = 0
path_state_3 = 1
path_new_state_3 = 0
registration_time = Mon Aug 11 20:35:27 2003
user_name = (null) (settable)
location = (null) (settable)
software_module = (null)
state = available
state_previous = unknown
state_change_time = none
event_count = 3
last_event_time = Mon Aug 11 20:48:20 2003
name = SCSI-WWID:0710002c:"SONY SDT-7000
:d01b003t00003l00000"
category = tape
architecture = SCSI
phys_location = bus-3-targ-3-lun-0
dev_base_name = tape0
model = SDT-7000
firmware_rev = 0192
read_ops = 3
write_ops = 9
read_bytes = 133120
write_bytes = 245760
current_density = 19
block_size = 0
records = 1
filemarks = 0
rewind_timo = 3600
space_timo = 3600
load_timo = 3600
space_eod_timo = 3600
resid = 120832
sense_info = 0
sense_key = 0
soft_err = 0
hard_err = 12
active_paths = 1
standby_paths = 0
failed_paths = 0
donot_use_paths = 0
path_fail_limit = 2
subsys_dev_handle = 1
path_fail_limit = 2
subsys_dev_handle = 1
manufacturer = SONY
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:31 EDT