SUMMARY: can't boot CD

From: kdea@alpine-la.com
Date: Mon Aug 04 2003 - 19:00:51 EDT


Thanks to Alan Rollow, Dan Byrd, Selden Ball, Dr. Blinn, Johan Brusche,
and Steve @inel.gov.

Most of you wrote off my poor little CD ROM drive and figured it was dead
:-) .

Alan Rollow seemed to have a little more faith in it, and suggested I look
at the I/O path. So I grumblingly pulled the DS20 off the shelf, removed
all the panels, blew off all the dust, checked, and tightened all the SCSI
cable connections. Put the box back together and powered it back up. The
machine finally booted off the CD with no further problem.

Thanks everybody, for your suggestions.

--Alan Rollow's response--
If other systems can indeed read the same disks, you need to start looking
at the device and the I/O path. In the first case, it apparently couldn't
even read the boot blocks. The 2nd got that far, but couldn't read the
file system. It could be the drive. It could be the I/O adapter
(probably a built-in IDE channel for the DS20).

---Original problem---
I am attempting to boot the operating system CD on our AlphaServer DS20
with firmware v6.5, and it doesn't seem to work. I have verified that
other machines can boot the CD but this particular machine cannot do so. I

would prefer the 5.1a disk to work over the other two versions, but that
gets even less far than older CDs.

When I use the Tru64 5.1a disk I get the following output

P00>>>boot dka500
(boot dka500.5.8.1 -flags A)
retries to pka0.5.0.8.1 exhausted(cmd-0 sts-2)
failed to open dka500.5.0.8.1
P00>>>

When I try to use the Tru64 5.0 and the Tru64 4.0f disk, I get the
following output:

P00>>>boot dka500
(boot dka500.5.8.1 -flags A)
block 0 of dka500.5.0.8.1 is a valid boot block
reading 14 blocks from dka500.5.0.8.1
bootstrap code read in
base = 200000, image_start = 0, image_bytes = 1c00(7168)
initializing HWRPB at 2000
initializing page table at 3ff44000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
can't open osf_boot

halted CPU 0

halt code = 5
HALT instruction executed
PC = 20000030

--
Kevin Dea
UNIX System Administrator
Alpine Electronics Research of America


This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:29 EDT