Configuration file options parameters

From: Dr. Otto Titze (titze@ikp.tu-darmstadt.de)
Date: Wed Mar 19 2003 - 09:58:05 EST

Next message: lawries@btinternet.com: "SUMMARY: Re-use of local install disk"
Previous message: Carl Christopher Bavington @ Langley: "Getting an IP address included in a who"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi all,

I just recently run into troubles when I wanted to instal AdvFS
After setld -l (OSFADVFS445,OSFADVFSBINOBJECT445), doconfig I could use
the commands but not mount (Message: AdvFS not installed"). I tried
setld -c <product> INSTALL no chance. Then I was searching
in/usr/sys/conf/NODE for a proper parameter, reading through different
sysman guides - Nothing. After some playing around "options MSFS" did it
for me. I made a similar exeperience before until I found that DLB is
important for LAT.

Question: Where do I find a description for the options parameters in
the
configuration file? (Just for future cases!)

Regards

Otto

-- 
 -------------------------------------------
| Dr. Otto Titze, Kernphysik TUD           |
| Schlossgartenstr. 9, D-64289 Darmstadt   |
| titze@ikp.tu-darmstadt.de                |
| Tel: +49(6151)16-2916,FAX:16-4321        |
 -------------------------------------------

Next message: lawries@btinternet.com: "SUMMARY: Re-use of local install disk"
Previous message: Carl Christopher Bavington @ Langley: "Getting an IP address included in a who"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:12 EDT