From: Siti.Hawa@reuters.com
Date: Mon Jan 13 2003 - 00:44:16 EST
Hi
I've a print queue defined in my Tru64 unix server (v4.0f) which sends to a dot matrix printer LA210
was via DecServer. This printer is now connected to a print server via serial port. Using the original
printcap except for the Ts & Op parameters pointing to the terminal server & service names, printout
came with additional line spacing after each printed lines.
My original printcap was as follows :
lp2|2|mma2:\
:af=/usr/adm/lp2acct:\
:br#9600:\
:ct=lat:\
:fc#0177777:\
:fs#023:\
:lf=/usr/adm/lp2err:\
:lp=/dev/lat/622:\
:mx#0:\
:of=/usr/lbin/lqf:\
:pl#66:\
:pw#132:\
:sd=/usr/spool/lpd2:\
:sh:\
:xc#0177777:\
:xf=/usr/lbin/xf:\
:xs#044000:\
:Op=PORT_12:\
:Ts=DSSMMA:
I've tried changing the fs# to 010. There was no extra line spacing but I get stair stepping.
Any idea how I can resolve this? I've seen similar problems reported in the forum but being
novice user, I'm not sure how I can apply them in my case. Also, is there any where I can get a
complete listings of the flag bits information. The Tru64 sys admin manual only gave a couple
of examples (under chapter Administring the Print Services).
tks in advance
hawa
--------------------------------------------------------------- -
Visit our Internet site at http://www.reuters.com
Get closer to the financial markets with Reuters Messaging - for more
information and to register, visit http://www.reuters.com/messaging
Any views expressed in this message are those of the individual
sender, except where the sender specifically states them to be
the views of Reuters Ltd.
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:49:03 EDT