From: Lisa.Morris@victorreinz.com
Date: Thu Sep 19 2002 - 12:16:28 EDT
After a lot of try this....try this...... the problem was with the firmware
version on our 2 gigabyte switches!!! The switches came with v3.02.c and
we updated them to v3.02.f and the the system booted up in the cluster
fine!!
Thanks to everyone who responded.
Lisa
Original Question was:
I have a cluster question/problem. I have an ES40 system and just
purchased an ES45 system. The ES45 system will boot up off of our cluster
disk - but I can't get the ES40 to boot up off of it. I don't get any
error messages at all....it just hangs. It looks like it can read the
genvmunix. I am running 5.1A. I can boot the ES40 up off of another drive
- just not the cluster drive!! I did add it to the cluster so I am not
sure what's going on? Waiting for Compaq to call me back - has anyone run
into this??
Lisa Morris
* * * * * L E G
A L D I S C L A I M E R * * * * *
WARNING: The information in this E-mail message is confidential and is
information intended only for the use of the individual(s) named above. If
you are not the appropriate recipient, you are hereby notified that you
should not further disseminate, distribute, or forward this E-mail message.
If you have received this E-mail message in error, please notify the sender
immediately. We have taken reasonable steps to ensure that this message
(and any attachments or hyperlinks contained within it) are free from
computer viruses and the like. However, in accordance with good computing
practice the recipient is responsible for ensuring that it is actually
virus free before opening it. Dana Corporation is under no duty to cover
any loss or damage caused by software viruses.
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:48:53 EDT