From: gschmid@notes.cc.sunysb.edu
Date: Wed Jul 03 2002 - 16:00:44 EDT
I installed a 2nd NIC in an AS4100 running 4.0E.
The card shows up when I do a >>> 'sh dev'
or a >>> 'sh config' in console mode, but not when
the system is up, so I assume that I have to do a
doconfig or sysconfig.
Questions:
1. Do I need to edit any files (e.g., /usr/sys/conf/ files)
before rebuilding the kernel to tell it where the
new tu1 device is?
2. Do I need to do a sysconfig or a doconfig?
TIA
This archive was generated by hypermail 2.1.7 : Sat Apr 12 2008 - 10:48:45 EDT