Sun Ultra 5 SCSI disk and IDE Disk issue

From: Peter Ferrigan (pete@peteland.org)
Date: Fri Feb 21 2003 - 15:30:38 EST

• Next message: Hackett, Peter: "Tracking Down Memory Leak"
• Previous message: Mike Demarco: "nvalias variables"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Good afternoon, Managers.

I've got an Ultra 5. I've got one 20GB IDE Drive. I've also got the
Symbios SCSI Card. I connected a Seagate 18GB SCSI drive to it and
attempted to install Solaris 8. I did a STOP-A and then a
probe-scsi-all to make sure that the SCSI card saw the drive and it did
- SCSI ID 3.

So, I continue with the install and put the swap slice on the IDE drive.
However, when I get to the part of the setup where I select drives to
install on, it doesn't show the SCSI drive - just the IDE. The IDE
drive is set to cable select, if that matters.

Is there something I am doing wrong? How do I get this SCSI drive to
show during setup?

Thanks in advance!

- Peter

- Peter
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers

• Next message: Hackett, Peter: "Tracking Down Memory Leak"
• Previous message: Mike Demarco: "nvalias variables"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:25:51 EDT