From: Sara SaiMohan (sarasai@hotmail.com)
Date: Sun Feb 16 2003 - 03:22:04 EST
Thank you for the prompt replies, I have one more problem, I amnot able to
send ctrl+A signal that we normally use as I am on a Sunfire 280 R and
unfortunately I am using a ttya console port onto windows terminal session.
I tried the umount -o rw,remount / option when I am in Single user mode, it
says either / is busy or it says no mount point
I am attaching the boot errors, pls help.
------------------------------------------------------------------
Rebooting with command: boot
Boot device: disk File and args:
SunOS Release 5.8 Version Generic_108528-18 64-bit
Copyright 1983-2001 Sun Microsystems, Inc. All rights reserved.
WARNING: forceload of drv/SUNW,qlc failed
WARNING: /pci@8,700000/scsi@3,1 (glm3):
Resetting scsi bus, got incorrect phase from (0,0)
WARNING: /pci@8,700000/scsi@3,1 (glm3):
got SCSI bus reset
WARNING: /pci@8,700000/scsi@3,1 (glm3):
Resetting scsi bus, got incorrect phase from (0,0)
WARNING: /pci@8,700000/scsi@3,1 (glm3):
SCSI bus reset recursion
WARNING: glm3: fault detected in device; service unavailable
WARNING: glm3: SCSI bus reset recursion
WARNING: forceload of drv/SUNW,qlc failed
WARNING: forceload of drv/pci failed
Starting VxVM restore daemon...
VxVM starting in boot mode...
configuring IPv4 interfaces: eri0 eri0:1 eri0:2 eri0:3.
Hostname: nhvoraclecorpge
swapadd: file system table (/etc/vfstab) not found
Usage:
mount [-v | -p]
mount [-F FSType] [-V] [current_options] [-o specific_options]
{special | mount_point}
mount [-F FSType] [-V] [current_options] [-o specific_options]
special mount_point
mount -a [-F FSType ] [-V] [current_options] [-o specific_options]
[mount_point ...]
failed to open /etc/coreadm.confsyseventd: Unable to open daemon lock file
'/etc
/sysevent/syseventd_lock': 'Read-only file system'mount: mount-point
/var/run do
es not exist.
VxVM general startup...
vxvm:vxconfigd: ERROR: Could not open file /etc/vx/array.info for writing
vxvm:vxconfigd: ERROR: enable failed: Error in disk group configuration
copies
Database file not found; transactions are disabled.
cat: cannot open /etc/vx/reconfig.d/saveconf.d/swapdev
/etc/vx/reconfig.d/saveconf.d/swapdev: No such file or directory
dumpadm: failed to open /etc/dumpadm.conf: Read-only file system
vxvm: Vold is not enabled for transactions
No volumes started
UX:vxfs qlogrec: ERROR: Cannot open file /etc/qlog/config.lock
UX:vxfs qlogrec: ERROR: Problem writing file /etc/qlog/config.lock: Bad file
num
ber
UX:vxfs qlogck: ERROR: Cannot open file /etc/qlog/config.lock
UX:vxfs qlogck: ERROR: Problem writing file /etc/qlog/config.lock: Bad file
numb
er
UX:vxfs qlogck: TO FIX: Command qlogck was not successful
UX:vxfs qlogck: WARNING: Fix whatever problem was encountered and rerun
UX:vxfs qlogck: WARNING: the command qlogck
UX:vxfs qlogck: WARNING: Running the command qlogck with the -f option
UX:vxfs qlogck: WARNING: will fix most of the problem(s) but will force
UX:vxfs qlogck: WARNING: a full consistency check (full fsck)
UX:vxfs qlogck: WARNING: on the VxFS volume(s) which cannot be fixed.
The QuickLog routine 'qlogck' encountered the errors mentioned above. It is
recommended that you enter the maintenance shell and attempt to correct
these problems. Once all possible corrections have been made, enter
Control-d to exit the maintenance shell, and initialization will resume.
See qlogck(1M) for assistance.
-----------------------------------------------------------------------
>From: "Sara SaiMohan" <sarasai@hotmail.com>
>To: sunmanagers@sunmanagers.org
>Subject: undoing a vfstab entry
>Date: Sat, 15 Feb 2003 22:30:34 -0800
>
>Hi All,
>
>I was kind of troubles shooting a vx problem and mistakenly commented the
>rootvol and var and swap entries of a vfstab and did a reboot...
>
>Now I am not able to re-edit the vfstab file. No matter what I do it says
>that it is a read-only file system. and it doesn't allow me to go into init
>1, it is always takingme into single user mode.
>
>Help appreciated
>
>
>
>
>
>_________________________________________________________________
>Tired of spam? Get advanced junk mail protection with MSN 8.
>http://join.msn.com/?page=features/junkmail
>_______________________________________________
>sunmanagers mailing list
>sunmanagers@sunmanagers.org
>http://www.sunmanagers.org/mailman/listinfo/sunmanagers
_________________________________________________________________
Add photos to your e-mail with MSN 8. Get 2 months FREE*.
http://join.msn.com/?page=features/featuredemail
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:25:50 EDT