From: Timothy Lorenc (tim@load.com)
Date: Thu Sep 05 2002 - 16:23:25 EDT
SUMMARY:
I successfully installed two Western Digital 120GB HDDs in a SunFire V100.
P/N: WD1200JB-00CRA1
NOTE for jumper settings:
I had to set the boot drive c0t0d0 to Cable Select.
And the second drive chained with the CD-ROM drive was set to Master.
Hope this information helps someone else out there.
-- ORIGINAL question below: I only found a single question about 129GB IDE HDDs with no summary in the archives. So I am going to ask: Is it possible to use 120GB IDE HDDs in a SunFire V100. And if so, which brand(s) or model(s) have you used. Thanks. -- LOAD your email! Timothy Lorenc USmail: Lorenc Advantage, Inc. Consultant 6732 E. State Blvd. PMB 304 Email: tim@load.com Fort Wayne, IN 46815 http://www.load.com ***DISCLAIMER*** If this communication concerns the negotiation of a contract or agreement, the Uniform Electronic Transaction Act does not apply to this communication: contract and/or agreement formation in this matter shall only occur with manually-affixed signatures on original documents. _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:24:53 EDT