From: Hector De Jesus (hec1979@gmail.com)
Date: Thu Dec 20 2007 - 16:59:45 EST
Hello Sunmanagers,
I have just completed a fresh install of Solaris 10 11/06 along with
EMC PowerPath v5.0.0.GA. I have followed all of the requirements
stated in the install documentation prior to the installation of
powerpath and after and when I run the following command "powermt
display dev=all" I cannot see any of the consolidated device paths.
My system can see all of the disks coming from the clariion. Also
when I run the following command " powercf -q" I get the following
error message "NO valid mapping entries in conf file!"
Has anyone run into a similar issue, did I miss something during
configuration? Any guidance would be greatly appreciated.
Regards,
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:42:37 EDT