From: Cruz, Alfredo (Alfredo.Cruz@cancercare.on.ca)
Date: Wed May 30 2007 - 12:03:35 EDT
Hello,
I have two interface card on my global zone. I need one configured with
an IP address (e1000g0) and the other plumb with no IP address
(e1000g1). The reason for this is so that local zone boots up with two
interface cards: one with e-1000g0:1 and the other with e1000g1:1 both
with valid IP addresses. Is it possible to setup the globalzone to
bring up the e1000g1 plumb without IP addresses? Do you have a better
solutions or better standard practice?
Thanks in advance.
Alfredo
DISCLAIMER:
This e-mail message (and any attachments) may contain confidential and/or
privileged information for the sole use of the intended recipient. Any review
or distribution by anyone other than the person for whom it was originally
intended is strictly prohibited. If you have received this e-mail in error,
please contact the sender and delete all copies. Opinions, conclusions or
other information contained in this e-mail may not be that of the
organization.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:42:00 EDT