From: Gary Brett (gary.brett@fidessa.com)
Date: Fri May 25 2007 - 05:05:44 EDT
Hi, I'm sure these are really simple questions to answer but I'm not quite
sure how to do this
1) How do I boot these x86 boxes off the network into single user mode?, with
sparc, I normally create a jumpstart profile, but rather than issuing a "boot
net - install" I issue a " boot net -s" specifically instructing it to go to
single user rather than install anything....Currently with our x86 boxes, we
just press f12 and that will prepare the system to be jumpstarted....ie
rebuilt......how do I get it to just boot into single user and not install
anything
2) is there an equivalent of the OBP 'banner' command that I can issue from
ILOM to get the box's MAC address
Any help on these would be greatly appreciated
Cheers
Gary
*****************************************************************************
*****************************************************************************
**********************************
This message is intended only for the stated addressee(s) and may be
confidential. Access to this email by anyone else is unauthorised. Any
opinions expressed in this email do not necessarily reflect the opinions of
Fidessa. Any unauthorised disclosure, use or dissemination, either whole or in
part is prohibited. If you are not the intended recipient of this message,
please notify the sender immediately.
Fidessa plc - Registered office:
Dukes Court, Duke Street, Woking, Surrey, GU21 5BH, United Kingdom
Registered in England no. 3781700 VAT registration no. 688 9008 78
Fidessa group plc - Registered Office:
Dukes Court, Duke Street, Woking, Surrey, GU21 5BH, United Kingdom
Registered in England no. 3234176 VAT registration no. 688 9008 78
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:41:59 EDT