From: Vitali Martiniouk (datentod@kilsol.com)
Date: Thu Apr 12 2007 - 15:57:46 EDT
Hello,
I just bought a Sun Netra T1 AC2000, however the system asks for a
"firmware password" after boot...
Anyhow, if I remove the system configuration card the system boots,
complains about the missing card and puts me at the "ok" prompt.
I entered a password command a set a new password, but I am not sure what
password does the password command change at the "ok" prompt.
I also read about stop+n sequence(to reset nvram), yet I do not have a sun
keyboard, and from what I gathered this command cannot be executed over
serial.
I am able to get to the lom prompt by entering the "#." at the ok prompt.
I need to type these commands to reset the nvram:
bootmode reset_nvram
reset
However the only command that seem to work at the lom prompt is the
ctrl+break (^C). anything else I type does not show up on my display(using
securecrt program via serial to netra), I know serial works since I can
use it fully at the ok prompt.
Is there a soft. fix or I need to get a new nvram from sun?
-- Best regards, Vitali Martiniouk mailto:vit@kilsol.com http://www.kilsol.com _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:41:52 EDT