From: Alex S. (alexals@kkipc.com)
Date: Sat Apr 15 2006 - 08:23:21 EDT
Hi all,
I got a problem to set 100Mbps / full-duplex mode on our SUN 1GB
Quadcard which is installed on our SUN V128R machine. I had configured
the first interface for 100Mbps / full-duplex and the rest are 1000Mbps
(by default). The reason is I have a TAP device which only supports up
to 100Mbps. Once I configured the first interface to 100Mbps through
/etc/rc2.d/S69inet and at the same time I 'hard-coded' the Cisco 6500
series (which has 1000Mbps interfaces) to 100Mbps / full-duplex, it does
not works and fall to 100Mbps half-duplex on the next reboot.
Below are the scenarios that I had done:
Server Switch Duplex
100Mbps 100Mbps Half-duplex
100Mbps Auto-sensing Half-duplex
Auto-sensing 100Mbps Half-duplex
1000Mbps Auto-sensing Full-duplex
Auto-sensing Auto-sensing Full-duplex
1000Mbps 1000Mbps Full-duplex
I did not install driver which came together with the card, since the
O.S. itself able to detect it automatically. The rest I manually defined
especially on network configurations.
Please help me. Advice me if there is a way to configure it to 100Mbps /
Full-duplex mode. If there is an issue discovered about this card, do
tell me the links. Thanks very much.
Regards,
Al
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:39:35 EDT