rsm6.22.1 unable to see A3500FC - any suggestions?

From: Peter Stokes (peter@ashlyn.co.uk)
Date: Fri Mar 17 2006 - 10:08:04 EST

• Next message: Brent: "setting ndd commands in Solaris 10"
• Previous message: John Horne: "Non-X keyboard mapping"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi All

Pretty frustrated here trying to setup an A3500FC.

I have tried on two separate systems with both 2.6 and 9 Solaris.

I have loaded the O/S (either 2.6 5/98 or Sol 9)

Added patches from patch matrix.

My Fibre card (FC100/P) works fine with A5000 and the A3500FC has an ID
of 5 when viewed from a PC which has a Qlogic card in it.

When I load RSM 6.22.1 it loads ok, except it reports it cannot find any
arrays.

eg

drvconfig: driver failed to attach: ssd
drvconfig: driver failed to attach: rdriver
drvconfig: driver failed to attach: rdriver
RDAC daemons initiated
WARNING: set_drivers: No arrays were found that are controlled by either
the sd
or the ssd driver

Can someone please put me out of my misery as to where to go from here
as I have been trying to get this sorted for a while!!

Also how can I verify if the FC100 can see the array controller or not?

Thanks

Peter
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers

• Next message: Brent: "setting ndd commands in Solaris 10"
• Previous message: John Horne: "Non-X keyboard mapping"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:39:19 EDT