From: Anjan Dave (adave@vantage.com)
Date: Thu Feb 02 2006 - 17:09:11 EST
Hi,
Just received a pair of v40zs, each ordered with a PCI-x RAID Card
(X9884A), which is an LSI Megaraid 320-2x. Apparently, since this is
new, no one at Sun knows exactly how to put this card in the system and
connect it to the SCSI back plane.
>From the few lines I found about it in the v40z manual online - I should
be using the PCI Slot0 (under the power supply cage), and connect a
cable to the SCSI back plane. The question is, channel A is already
connected, should I just remove it and extend the cable to connect it on
the PCI card, or use some sort of an extension cable if it's not long
enough? Is there a specific way it has to be routed?
Although it's simple, I would like to do this the correct way if
possible. Appreciate if anyone can share the knowledge!
Thanks,
Anjan
This email message and any included attachments constitute confidential
and privileged information intended exclusively for the listed
addressee(s). If you are not the intended recipient, please notify
Vantage by immediately telephoning 215-579-8390, extension 1158. In
addition, please reply to this message confirming your receipt of the
same in error. A copy of your email reply can also be sent to
mailto:support@vantage.com <blocked::mailto:support@vantage.com> .
Please do not disclose, copy, distribute or take any action in reliance
on the contents of this information. Kindly destroy all copies of this
message and any attachments. Any other use of this email is prohibited.
Thank you for your cooperation. For more information about Vantage,
please visit our website at http://www.vantage.com.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:38:50 EDT