HP network printer conf in solaris 10

From: Ambati, Sugunakar (s1ambati@fcg.com)
Date: Mon Jan 16 2006 - 09:50:07 EST


Hi gurus,

Installed hp jetdirect software and able to take test prints with
hpjetadmin software.

Then I configured print queue on solaris 10 like the following:

1. lpadmin -p queue_name -v /dev/null

2. lpadmin -p queue_name -i /usr/lib/lp/model/netstandard

3. lpadmin -p queue_name -o dest=192.168.105.9:9100 -o
protocol=bsd -o timeout=time_in_seconds

4. Even tried with lpadmin -p queue_name -o dest=192.168.105.9
-o protocol=bsd -o timeout=time_in_seconds

5. Type: enable queue_name

6. Type: accept queue_name

All these comands run successfully, but when I issue lp -d
192.168.105.9:9100 test , then I get error

"lp connection to 'lpserve' failed - No Error" . Tried with lpr too.

Even used printmgr to configure the same, but still the problem
persists.

Please help me. I Promise to summarise.

Regards

sugun

This email may contain material that is confidential, privileged and/or
attorney work product for the sole use of the intended recipient. Any review,
reliance or distribution by others or forwarding without express permission is
strictly prohibited. If you are not the intended recipient, please contact the
sender and delete all copies.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers



This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:38:30 EDT