From: Tim Evans (tkevans@tkevans.com)
Date: Wed Sep 28 2005 - 18:19:00 EDT
This seems not to have shown up in more than 24 hours...
------------- Begin Forwarded Message -------------
Date: Tue, 27 Sep 2005 17:38:33 -0400 (EDT)
From: Tim Evans <tkevans@osprey>
Subject: Activating HotSpare in A1000 with RaidManager
To: sunmanagers@sunmanagers.org
Content-MD5: kZGMsDzlOIVGAVAu+mRxvg==
I have an A1000 under control of RaidManager 6, set up for RAID 5, with 12 disks
on one LUN. Both one of the 11 data disks *and* the hotspare have failed.
I replaced the hotspare with a new disk, thinking it would automagically become
active and take over for the other failed disk. RaidManager showed the LUN
being reconstructed after installing the new disk, but now shows the hotspare in
"standby" status.
LUN is still showing its status as "degraded," with 10 good disks and one failed
one.
How do I make the current hotspare take over? Just pull the bad one?
-- Tim Evans, TKEvans.com, Inc. | 5 Chestnut Court tkevans@tkevans.com | Owings Mills, MD 21117 http://www.tkevans.com/ | 443-394-3864 http://www.come-here.com/News/ | ------------- End Forwarded Message ------------- Tim Evans, TKEvans.com, Inc. | 5 Chestnut Court tkevans@tkevans.com | Owings Mills, MD 21117 http://www.tkevans.com/ | 443-394-3864 http://www.come-here.com/News/ | _______________________________________________ sunmanagers mailing list sunmanagers@sunmanagers.org http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:31:51 EDT