From: abdul.mannan@wipro.com
Date: Fri Aug 26 2005 - 07:14:48 EDT
Hi Gurus,
I am having An L25 with a M300 prism management card and FC420 fiber
channel bridge along with two drives.
The problem is that when i power it on with proper cabling i am getting
"waiting for drive comms" message for both drives on the L25 display
panel....i think that l25 is not detecting the drives ...also the robotic arm
on scsi id 0 is getting detected...the scsi ids for the two drives is 1 and 2
...also when i telnet the l25 and run command scsitarget 0 it shows me the
entry for robotic arm but when i run the same command for scsi id 1 and 2 ....
there is no output...
Any idea?????????
Thanks & regards,
Abdul Mannan
Confidentiality Notice
The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
Mailadmin@wipro.com immediately
and destroy all copies of this message and any attachments.
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:31:24 EDT