From: HRISHIKESH KULKARNI (hrk007@yahoo.com)
Date: Mon Aug 22 2005 - 17:28:15 EDT
Hi all,
We have a SUN ENTERPRISE E4500 server connected to
three daisy chained A5200 disk arrays. Veritas is used
to configure a RAID 1+0 scheme for the disk arrays( 4
volumes of filesytem type ufs) and also for mirroring
the two internal boot disks.
On booting the machine (which has been working fine
for some months) after a hard shutdown for server room
maintenance, the solaris doesnt boot up after a
certain point. Following are the messages on the
console. It also seems a CPU/MEM board has gone
faulty(however this should not prevent booting)
FCode UFS Reader 1.11 97/07/10 16:19:15.
Loading: /platform/SUNW,Ultra-Enterprise/ufsboot
Loading: /platform/sun4u/ufsboot
SunOS Release 5.8 Version Generic_117000-03 64-bit
Copyright 1983-2003 Sun Microsystems, Inc. All rights
reserved.
WARNING: status 'fail- mem-bank0: J3300 ' for
'/fhc@e,f8800000/ac@0,1000000' on
board 7
WARNING: forceload of drv/SUNW,fas failed
FCode UFS Reader 1.11 97/07/10 16:19:15.
Loading: /platform/SUNW,Ultra-Enterprise/ufsboot
Loading: /platform/sun4u/ufsboot
SunOS Release 5.8 Version Generic_117000-03 64-bit
Copyright 1983-2003 Sun Microsystems, Inc. All rights
reserved.
WARNING: status 'fail- mem-bank0: J3300 ' for
'/fhc@e,f8800000/ac@0,1000000' on
board 7
WARNING: forceload of drv/SUNW,fas failed
tarting VxVM restore daemon...
VxVM starting in boot mode...
NOTICE: vxvm:vxdmp: added disk array 5080020000089f90
NOTICE: vxvm:vxdmp: added disk array 50800200000894d8
NOTICE: vxvm:vxdmp: added disk array 5080020000089458
NOTICE: vxvm:vxdmp: added disk array SEAGATE_DISKS
configuring IPv4 interfaces: ge0.
Hostname: dbserver1
VxVM starting special volumes ( swapvol )...
SUNW,sbus-gem0: Using Gigabit SERDES Interface
SUNW,sbus-gem0: Auto-Negotiated 1000 Mbps Full-Duplex
Link Up
VxVM general startup...
dumpadm: no swap devices could be configured as the
dump device
The system is coming up. Please wait.
checking ufs filesystems
/dev/vx/rdsk/grp04/vol04: is clean.
/dev/vx/rdsk/grp03/volgrp03: is stable.
and after this it just hangs
Below is vfstab output of this machine that was
backedup recently and had not undergone any changes.
#device device mount FS fsck mount mount
#to mount to fsck point type pass at boot options
#
#/dev/dsk/c1d0s2 /dev/rdsk/c1d0s2 /usr ufs 1 yes -
fd - /dev/fd fd - no -
/proc - /proc proc - no -
/dev/vx/dsk/swapvol - - swap - no -
/dev/vx/dsk/rootvol /dev/vx/rdsk/rootvol / ufs 1 no -
swap - /tmp tmpfs - yes -
#NOTE: volume rootvol (/) encapsulated partition
c0t10d0s0
#NOTE: volume swapvol (swap) encapsulated partition
c0t10d0s1
/dev/vx/dsk/grp01/vol01 /dev/vx/rdsk/grp01/vol01
/DATA1 ufs 3 yes -
/dev/vx/dsk/grp02/vol02 /dev/vx/rdsk/grp02/vol02
/DATA2 ufs 3 yes -
/dev/vx/dsk/grp03/volgrp03 /dev/vx/rdsk/grp03/volgrp03
/DATA3 ufs 1 yes -
/dev/vx/dsk/grp04/vol04 /dev/vx/rdsk/grp04/vol04
/DATA4 ufs 3 yes -
Please let me know what could be probable cause and
the possible solution for the problem.
Regards,
Hrishi.
____________________________________________________
Start your day with Yahoo! - make it your home page
http://www.yahoo.com/r/hs
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
This archive was generated by hypermail 2.1.7 : Wed Apr 09 2008 - 23:31:22 EDT